Prime the surface with Life Deck 11 Series epoxy primer. The first coat or primer soat should be cut back with water to insure maximum penetration of the surface. Premix each side A & B. Combine 1 quart of part A with 1 quart of part B and mix for 2 minutes. Then add 1 quart of water and mix for 1 more minute. Combine using an agitator, jiffy mixer or stir stick. The primer is ready to be applied by brush, spray or roller. Coverage should be approximately 200-300 sq. ft. (or 1 to 2 dry mils) per 2/4 gallon batch. Mix only what you will use within 2 hours. Descard unues mixed primer.

Apply LD 220 to substrate at a rate of 50 square feet per gallon. For best results use a notched trowel or notched squeegee and back roll to even out the material. Allow LD 220 to cure, usually 24 hours (or until firm enough to walk on) before additional coats.

Apply a second coat of LD 220 at a rate of 100 spuare feet. per gallon. Immediately broadcast the desired aggregate, such as #2-16 Monterey sand or #20 silica sand (sand aggregates should washed and kiin dried), at a rate of 100 lbs/100 square feet into the wet coat. The aggregate should completely cover the surface. After 24 hours, remove loose aggregate by broom or vacuum.

Apply Desired color of LD221 Top Coat at a rate of 100 square feet per gallon. For best results use a squeegee and a back roll to even out the material.. Airless sprayer or phenolic core roller may be used but, extra care should be taken to prevent air bubbles.

Optional Second Top Coat: Apply a second coat of LD221 Top Coat at a rate of 200 square fee. Allow 72 hours of cure time before permitting heavy traffic on the finished system.